Guides

How to Run BULLET SPOOFER: Step-by-Step Guide

How to Run BULLET SPOOFER: Step-by-Step Guide

BULLET SPOOFER is a temporary HWID spoofer that covers 24 games, including Rust, Apex, Fortnite, Arc Raiders, Delta Force, The Finals, DayZ, R6 Siege and Dead by Daylight. It is built for EAC, EAAC, ACE, BattlEye, Ricochet, PunkBuster and EFT protection. Below you will find the developer's launch order plus everything worth preparing in advance so the spoof works on the first try.

Before You Start

First, check that your system fits:

  • Windows x64, from 10 20H2 up to 11 26H2;
  • GPT or MBR disk, BIOS in Legacy or UEFI mode;
  • Wi-Fi is supported and no USB stick is needed;
  • TPM 2.0 and Secure Boot are supported, but if you use TPM, turn BitLocker off.

Then turn off what gets in the spoofer's way:

  • HVCI and VBS. Open Windows Security → Device security → Core isolation and switch off Memory integrity.
  • Smart App Control. You will find it under App & browser control in the same Windows Security app.
  • Driver Signature Enforcement. Go to Settings → Recovery → Advanced startup → Troubleshoot → Advanced options → Startup Settings. After the restart, press F7.
  • All antivirus software, Windows Defender included. We walk through it in our separate guide on turning off Windows protection.

Step-by-Step Launch

  1. Disable Driver Signature Enforcement, all antivirus software and Smart App Control as shown above.
  2. Go to the developer's website. The link shows up in your account right after payment.
  3. Enter your key there and download the loader.
  4. Open the loader and enter your key again.
  5. Click Spoof.
  6. Wait for the process to finish, and only then turn on your VPN.
  7. Launch the game.

Temporary Spoofer: What to Keep in Mind

BULLET SPOOFER runs in temp mode. The spoof lasts until you restart your PC and resets after a reboot. So before every gaming session, open the loader and click Spoof again.

The easiest way to remember it is a short loop: reboot, Spoof, wait, VPN, game. If you restart your PC halfway through the evening, just start the loop again from Spoof.

Common Issues

Spoof does not go through. Double check that Memory integrity (HVCI and VBS), Smart App Control and Driver Signature Enforcement are all off. If any of them is still on, the spoofer will not work properly.

BitLocker is on and the PC uses TPM 2.0. TPM itself is supported, but BitLocker has to be turned off before you launch.

The VPN was turned on too early. Order matters here: Spoof first, wait for it to finish, then VPN. If your VPN was already on, disconnect it, run Spoof again and reconnect once it is done.

The spoof is gone after a reboot. That is expected, since the spoofer is temporary. Click Spoof again before you jump into a match.